多功能攪拌車的減震器失效或者出現問題,應查看減震器是否有漏油現象,用力按下保險杠,然后松開,假如攪拌車有兩到三次的騰躍,就說明減震器是好的。
If the shock absorber of the multi-functional mixer fails or has problems, first check whether the shock absorber has oil leakage, press the bumper firmly, and then release it. If the mixer has two or three jumps, it means that the shock absorber is good.
多功能攪拌車在緩慢行駛中緊急制動,此時如果車輛的振動比較厲害,就說明減震器有問題,需要拆下減震器將其直立,并把下端銜接環夾在臺鉗上,用力拉壓減震桿數次,此時應有穩定的阻力,往上拉的阻力應大于向下的阻力,如果阻力不穩定或無阻力,可能是減震器內部缺油或閥門零件損壞,應終止修復或更換零件,并應立即送去維修。
In case of emergency braking during slow driving of multi-functional mixer, if the vibration of the vehicle is severe, it means that there is a problem with the shock absorber. It is necessary to remove the shock absorber to stand it upright, clamp the lower connecting ring on the vise, and pull and press the shock absorber several times with force. At this time, there should be stable resistance. The resistance to pull up should be greater than that to pull down. If the resistance is not stable or there is no resistance, it may be In case of lack of oil in the shock absorber or damage of valve parts, the repair or replacement of parts shall be terminated and the parts shall be sent for repair immediately.
多功能攪拌車減震器漏油一般是以下幾個原因:
The oil leakage of the shock absorber of the multi-functional mixer is generally caused by the following reasons:
1. 減震器內部的清潔度不夠好,有焊渣、鐵屑等雜物導致油封磨損。
1. The internal cleanliness of the shock absorber is not good enough. There are welding slag, iron chips and other sundries that cause the oil seal to wear.
2. 減震器的工作條件比較惡劣,外部的泥沙等雜物進入油封,導致其磨損漏油。
2. The working condition of the shock absorber is relatively poor, and foreign matters such as external sediment enter into the oil seal, resulting in its wear and oil leakage.
3. 減震器油封的唇口老化,失去了密封的功能。
3. The lip of the oil seal of the shock absorber is aged and has lost the function of sealing.
4. 可能是在噴底盤裝甲的時候,減震器沒有遮擋好,裝甲附在減震器活塞桿上導致油封磨損而漏油。
4. It may be that the shock absorber is not well covered when spraying chassis armor, and the armor is attached to the piston rod of the shock absorber, which causes the oil seal to wear and leak.
5. 控制活塞運動的支桿需要在金屬管的一端延長出來,所以這個部位必須得密封嚴密,一般的漏油都和密封不嚴有直接關系的。
5. The strut to control the movement of the piston needs to be extended at one end of the metal pipe, so this part must be sealed tightly. The general oil leakage is directly related to the loose sealing.
一般攪拌車的液壓的減震器漏油就說明它的使用年限已到。
6. The oil leakage of the hydraulic shock absorber of the general mixer indicates that its service life has reached.
多功能攪拌車底盤的減震器是非常重要的,很多人在做保養的時候都容易忽略它,希望看了這篇文章,大家能夠對減震器引起重視。我公司是生產攪拌車廠家,歡迎來電咨詢攪拌車價格,多功能攪拌車的官網http://www.cqkangxinda.com
The shock absorber of the multi-functional mixer chassis is very important. Many people tend to ignore it when they do maintenance. I hope you can pay attention to the shock absorber after reading this article. Our company is a professional manufacturer of mixer truck. Welcome to inquire about the price of mixer truck and the official website of multifunctional mixer truck http://www.cqkangxinda.com